ATTENTION: TURBOCHARGER INSTALLER
Be sure to refer to the vehicle manufacturers service manual. When installing the turbocharger the following should be observed.
CHANGE THE ENGINE OIL. Use only a type and grade of oil which is specified in the vehicle manufacturers service manual. Oil additives should not be used unless specifically approved by the vehicle manufacturer.
THOROUGHLY CLEAN THE TURBOCHARGER OIL FEED AND RETURN LINES. If necessary remove the lines to clean or replace.
CHECK FOR AND REMOVE ANY FOREIGN OBJECTS which may be in the compressor inlet pipe, intercooler or exhaust manifold that connect to the turbocharger.
IF REPLACING TURBOCHARGER CENTER HOUSING AND ROTATING ASSEMBLY (C.H.R.A) ONLY after attaching the end housing to the C.H.R.A be sure all bolts are secure and torqued per the vehicle manufacturers service manual specification.
BEFORE STARTING, CRANK ENGINE OVER WITHOUT STARTING until oil flows freely from oil feed pipe. Connect oil feed pipe.
START ENGINE AND ALLOW TO IDLE FOR AT LEAST 3 MINUTES. Do not rev engine during this time.
CHECK FOR ANY OIL OR EXHAUST LEAKS
